[. . . ] Audiocom SS1002/SS2002 Supplemental Information
Installing the Box to the Faceplate
General Instructions
If you ordered SS1002/ SS2002 boxes and faceplates separately, use these instructions to assemble the speaker stations. [. . . ] (Or in the case of the "U" box, connect wires from the intercom system to the terminal strip. ) To insert a wire into the terminal strip, push back the green lever on the top of the terminal as shown, then insert the wire and release the lever.
XLR Connector on Box Pin 1 Pin 2 Pin 3
TABLE 1. SS1002
Terminal Strip on Circuit Board TB1-1 TB1-3 TB1-4
Description DC Common Audiocom Channel audio low and +24VDC phantom power Audiocom Channel audio high and +24VDC phantom power
wire connections for use in Audiocom System
XLR Connector on Box Pin 1 Pin 2 Pin 3
TABLE 2. SS1002
Terminal Strip on Circuit Board TB1-1 TB1-3 TB1-4
Description Common Clear-com power input Clear-com audio / call signal
wire connections for use in Clear-com System
9330-7627-000 Rev C
07/2009
TABLE 3. SS2002
wire connections for use in Audiocom System Terminal Strip on Circuit Board TB1-1 No connection TB1-3 TB1-4 TB1-5 TB1-6 Audiocom Channel 1 audio low and +24VDC phantom power Audiocom Channel 1 audio high and +24VDC phantom power Audiocom Channel 2 audio low and +24VDC phantom power Audiocom Channel 2 audio high and +24VDC phantom power Description Common
XLR Connector on Box Pin 1 Pin 2 Pin 3 Pin 4 Pin 5 Pin 6
TABLE 4. [. . . ] When connected as shown, Clear-com Line A corresponds to SS2002 Ch 1 and Clear-com Line B corresponds to SS2002 Ch 2.
Step 2: Assemble the Faceplate to the Box. [. . . ]